Subaru Impreza GC8 & RS Forum & Community banner

Body panel repair

3 reading
3.3K views 2 replies 3 participants last post by  Caseyl  
#1 ·
doing rust repair on my cars rear fender/bumper joint (the usual scooby place) just wanted to know what sort of thickness is good to use for the replacement sheet metal i'm welding in
 
#2 ·
Bump. Does anyone know the answer? I heard anything from 18, 20, to 22 gauge. I was just wondering if anyone knew the specific gauge that's on our subarus so when the time comes I know what thickness sheetmetal to use for a patch panel. Thanks