Subaru Impreza GC8 & RS Forum & Community banner
1 - 8 of 8 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I know that GD sedan sway bars do not fit because the sway bar is wider than than the GC sway bar.

BUT!!!

If my theory is correct, the GC8/GF8 chassis is the same WIDTH as the GD wagon.

Im looking to upgrade my swaybars but its hard to find parts for a 96 OBS.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·

·
Registered
2000 Impreza 2.5RS BRP
Joined
·
3,574 Posts
Are you running a stock engine and cross member? Whiteline offers sway bars for your car if you're looking to upgrade both front and rear. If you're just looking to run OEM upgrades, I wouldn't so much worry about the front bar as I would the rear, which will take any GD non-STI sway bar without issue. The front bar can be left stock, as it's the same size as the WRX bars.
 

·
Registered
97 OBS 5MT
Joined
·
14 Posts
Confirmed - running a WRX rear on my 97 OBS. Bolted right up and fixed the understeer. Try this before you spend a lot of money on aftermarket bars.

If you're just looking to run OEM upgrades, I wouldn't so much worry about the front bar as I would the rear, which will take any GD non-STI sway bar without issue. The front bar can be left stock, as it's the same size as the WRX bars.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top