I was thinking about putting an A/F gauge and EGT gauge in the location where the stock radio once was with a S-AFC under or over them will they both fit? Since the radio is moved up to the Gauge pod its just two pockets there right now and I don’t think I am going to get what I want as far as an A-pillar that looks clean. Has anyone done this? I think 8 complex has the gauges right there? Is there a din sized gauge cluster to fit?
Where to put gauges.....
1 - 2 of 2 Posts
Go to someplace like Tap Plastics and get a 1/4" thick plastic sheet, drill four holes for the screws to mount where the original factory radio was, and then use a hole drill (not a hole saw, though) and cut holes for your guages. You can also probably use a small saw or Dremel to cut the hole for the S-AFC.
Takes some time, but looks good when done right.
And remember...
Measure twice, cut once. Measure once, cut twice.
Takes some time, but looks good when done right.
And remember...
Measure twice, cut once. Measure once, cut twice.
1 - 2 of 2 Posts
