Subaru Impreza GC8 & RS Forum & Community banner

1 - 1 of 1 Posts

·
Registered
Joined
·
323 Posts
Discussion Starter #1 (Edited)
Here is a new one.. OK I have a Aisin waterpump.. got a new gasket.. reused the T-stat from my EJ25D, I go to install it with the jiggle pin down and WTF the brass pointy end of the T-stat hits the housing leaving me with about a one inch gap?

I've never had this issue before, I'm not sure what to do.. this is not the first time I changed the T-stat but to be so far off in the fit is something I just don't understand.

I will get a picture.

holy crap haha I saw what the issue was.. too embarrassed to tell but it was the hose clamp for the heater bypass lol I guess that's what happens when you are up for over 10 hours...
 
1 - 1 of 1 Posts
Top