Subaru Impreza GC8 & RS Forum & Community banner

141 - 160 of 1743 Posts

·
Experimenter
Tubaru Pickup
Joined
·
3,910 Posts
Discussion Starter #142 (Edited)
Took a few minutes to tack together diff mount and stuck the driveshaft in to take some tunnel measurements. Looks like I'm going to need to make a fancy midpipe that crosses under driveshaft. That will get me the room to install two 21" wide seats symetrically.



 

·
Registered
Turbo, LS swapped Impreza RS
Joined
·
5,169 Posts
All good ideas were created on table placement items.

Sent from my SM-N920V using Tapatalk
 

·
Baby❤Daddy
98L Wagon
Joined
·
27,852 Posts
can the exhaust not be run over the driveshaft. you already have to make the trans tunnel to fit. just a little bit of extra room for the piping.
 

·
Experimenter
Tubaru Pickup
Joined
·
3,910 Posts
Discussion Starter #155
ive been pursuing this 3.5" exhaust option. i found a U bend i can work to make the offset under shaft. I couldnt find any freebie pipe but i have a RFQ in to Alro to see what it would cost to add 10' to my next order
 
141 - 160 of 1743 Posts
Top