Subaru Impreza GC8 & RS Forum & Community banner

Swap Electrical Testing

634 views 14 replies 3 participants last post by  camaroz1985 
#1 ·
Would it work/be worth it to put a battery in the car and test the electrical stuff while I'm waiting on my engine? I just want to try to get as many bugs worked out as I can before the engine gets here.
 
Discussion starter · #12 ·
Ok so I got it all back in and threw a battery in there. I get most of the stuff functioning as normal. There are a few things that I have noticed that are odd.

First, the fuel pump doesn't prime. I get 11.5V at the FPC and 10.4V coming from the FPC. I also get 10.4V at the fuel pump plug, so I'm guessing that the "brand new" pump that came with my swap is not any good. Is there really a difference between the 98 RS pump and the 07 WRX pump?

Also the blower works only on high speed. I know this is usually a symptom of a bad blower motor resistor, but it worked fine when I started things. Could banging it around while taking out the blower box have messed it up? What are the normal readings for resistance?

Also is there any way to check if the immobilizer is functioning properly? There is signal sent to the fuel pump, but is that proff the immobilizer is working?

Any help would be appreciated guys, thanks.
 
Discussion starter · #15 ·
Ok pulled fuel pump back out and connected directly to a battery, it runs. Put it back in the assembly and did some more testing, still doesn't work. Rechecked all the connections they are all fine. When I bypass the FPC it runs. I notice that when the FPC is connected it gets a voltage, but no amps. I'm hoping this is one of those strange things you talked about Keener.

Oh and the resistor was bad. A little ball of solder had fallen off. Resolder it, and its good as new. Thanks a lot!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top