Ok i am at work so i only got to do a quick search. I have a 96L with a swaped wrx engine. when we where taking the dash apart to put a 04 wrx dash in we had to take out the L steering column. Well when we were taking out the linkage at the end, the last person who took it out stripped every damn bolt. So after finally getting it out I just decided to replace it with an RS steering column. Only prob now is the hole that the steering column goes through, is too small for both rubber boots(L and RS boots) If i put the L boot in only the column doesnt seal right. and the same when you put in the rs one. Is there some aftermarket cure or do i have to sit there for hours trying to get both boots in the same damn hole?