[Imprezawd]

Ok RS25 Clubbers,
WHo has the fastest 1/4 mile RS out their!! I know Fun is not a straight line, but it can be on some occasions!! :nuetron:

Well post up I am hoping to run high 14's once i install my tranny mount , fidanza flywheel, act clutch, my intake hood bonnet scoop, and tein suspension?? Last time I ran my RS was 1.5 years ago. I ran a 15.3 1/4 intake and exhaust and UD pulley!!

I now we have faster than that on this BOARD!!

 

[Area1320]

15.1...apexi exhaust , u-drive pulley, cobb intake. tein springs
TRi tuning short throw, cusco front strut bar, TRi tuning rear strut bar. ....I can run these times all day long with a full interior

 

[Imprezawd]

impresive!!1

sideways very nice time!!
Where do u live. I live IN va. I am asking b/c different climates can make a little difference too!! I wonder if my short throw will help at all ??

Richie

 

[Area1320]

thanx...I live in PA but I race in New [email protected] Englishtown and Island...dunno what the "sea level is" but I can find out for ya.
I know my times at ISland are a bit off compared to Englishtown because of the elevation, I get more consistant runs @ Englishtown.

 

[Imprezawd]

U live Close!!

Hey sidewayz!!,

We arent too far from each other!! Have you been to any recent Carlisle Custom Compact Power Jam!!>>??? I went to the 2000 and to 2001 jams!!/ I am going this year for sure!!

Are u going to go this year?? ALways MAD SUBY show!! always !!! Englishtown has some killer shows as well. I even think ESPN rolls out to some of their NIRA events!!!

Well good time!!
Richie Rich
this is my ride

 

[Area1320]

I have been going to the Carlisle show for the past 5 years
I'll be there again this year, I will be in TRi Tunings booth..

 

[Myxalplyx]

Fastest Times

Well,

Any more updates as to who has the fastest times? I'm interested in knowing the fastest auto time as well or at least a fast auto time. What are autotrannied N/A times typically like?

Dcoty may still have the fastest N/A but I'm sure there are a lot more fast N/As out there now.

And I know this post is old as dirt.

 

[4wdFury]

the question is: who cares? subarus were destined/designed for bigger and better things than quarter mile antics.

 

[ratt_finkel]

the question is: who cares? subarus were destined/designed for bigger and better things than quarter mile antics.

 

[THUMPER98RS]

the question is: who cares? subarus were destined/designed for bigger and better things than quarter mile antics.

I pretty well agree with that after having my Camaro and running mid 12's. 1/4 mile can get boring and it really kills the car. I spent 5k on a 9" rear end after blowing up 3 stock ones.

 

[Area1320]

wow..this post is old..
well with an ACT clutch , Exedy flywheel, STI tranny mounts and some COBB stickers(good for 5hp) I have managed squeeze a 14.9 out of her..and thats with 17's (gram lights) adn full interior

 

[Area1320]

the question is: who cares? subarus were destined/designed for bigger and better things than quarter mile antics.

and youre a tool

 

[Ruff]

Injen intake, Borla header, ApexI N1 catback, Perrin Pulley, Exedy street clutch, Exedy Lightweight Flywheel (the flywheel makes it harder to launch - less enertia). Stock weight.

60'--------1.976
330'------6.009
1/8-------9.406 at 71.85 mph
1000'----12.384
1/4--------14.910 at 89.17 mph

 

[Soon2BturbodRS]

Yeah Adam! Hopefully you can break into the 14.8s or 14.7s tonight with your high-flow cat on now - pending it doesn't rain.

 

[Ruff]

Hopefully! It's pulling hard now! Installing a new gasket right now, and that flat4 extender.

 

[Area1320]

W00T another 14 sec RS

 

[JC]

Injen intake, Borla header, ApexI N1 catback, Perrin Pulley, Exedy street clutch, Exedy Lightweight Flywheel (the flywheel makes it harder to launch - less enertia). Stock weight.

60'--------1.976
330'------6.009
1/8-------9.406 at 71.85 mph
1000'----12.384
1/4--------14.910 at 89.17 mph

So what are you doing to launch? I can't get a decent launch worth a damn anymore, but then I don't really try. I *should* be faster than you. Though I'm sure my poor driving and heavy rims would have something to say about that.

JC

 

[4wdFury]

my setup is close to yours. I've been told I should be able to break into the 14s. I've just never tried. Maybe at the next test n tune...

 

[Ruff]

So what are you doing to launch? I can't get a decent launch worth a damn anymore, but then I don't really try. I *should* be faster than you. Though I'm sure my poor driving and heavy rims would have something to say about that.

JC

Holding revs to about 4500 and quickly sliping the clutch. I get some wheel spin. Why *should* you be faster then me? With the mods shown on your website, you shouldn't, but what do you have done?

 

[JC]

Holding revs to about 4500 and quickly sliping the clutch. I get some wheel spin. Why *should* you be faster then me? With the mods shown on your website, you shouldn't, but what do you have done?

I was like website, what the hell. I forgot I even had that, lol. Current mods...

Cobb Tuning Intake
Mr. Josh Pulley
MRT headers / cat
Greddy Cat-Back
Exedy Clutch / Flywheel
Prodrive P7s (re: heavy)

Guy I bought my headers from ran a 14.7 w/o the clutch/flywheel but with a chip.

JC