Subaru Impreza GC8 & RS Forum & Community banner

1 - 9 of 9 Posts

·
Registered
99 rs w/ EJ205
Joined
·
982 Posts
Discussion Starter #1
i went to change my calipers today, and when i put the wrench on one of the bracket bolts (17mm) i found out that its rounded....so before i tackle this thing with some vicegrips and a torch. How would u go about doing this?
 

·
Registered
2006 Impreza WRX Limited
Joined
·
2,603 Posts
i wouldnt try to use those with an impact wrench...cause if you fuck up even a little then it will strip it worse and you will have NO chance of getting it out...
 

·
Registered
Aspen White '03 2.5TS Wagon
Joined
·
1,091 Posts
I know it's too late, but I would have taken a slightly smaller socket, beat it on w/ a hammer, and went to town on it!
 
1 - 9 of 9 Posts
Top