Subaru Impreza GC8 & RS Forum & Community banner

1 - 3 of 3 Posts

·
Registered
05 OBP STi
Joined
·
427 Posts
Discussion Starter #1
im doing a version 4 RHD swap in my 95L and am having problems lining up my wiper motor. what have you guys done for this similar swap?



 

·
Registered
95 RHD WRX
Joined
·
1,799 Posts
This took me 6 hours. It was by far the most painful part of my RHD swap. I can't really tell what you're doing from pictures but I drilled out the RHD bracket from the rhd clip and estimated its placement on my usdm shell then riveted it in. It was a little too close to ther ight so the wiper scrapes a bit but I just hit it up with some hose and its ok now.
 

·
Registered
05 OBP STi
Joined
·
427 Posts
Discussion Starter #3
fixed it!!!! thanks for the reply derek.

had to just drill my own mounting holes that would make the center of the motor in the center of the hole. also had to cut a bunch off the top of the support that can be seen in the first pic.
 
1 - 3 of 3 Posts
Top