Subaru Impreza GC8 & RS Forum & Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I just installed a exedy oe clutch/flywheel kit in my 00. The clutch works fine but now I cant grab fourth gear. It feels like its trying to grab the very tips of the teeth but I don’t seem to have enough throw to get through the gate.

Any advice on where to start looking would save me some time.

Thanks guys

Nic
 

·
Registered
01 RScoupe,02WRX
Joined
·
111 Posts
bent main shaft backing plate

When you reinstalled the trans onto the engine did you have the splines on the main shaft and clutch disk aligned properly? If not you may have bent the main shaft backing plate. I've done this before. Does second gear seem like it wants to pop out when you depress the accelerator? I'm guessing that's your problem. When you install the trans onto the engine you should'nt have to force it on. It should just slide together.
 
1 - 2 of 2 Posts
Top