Subaru Impreza GC8 & RS Forum & Community banner

1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I tried a search - came up with nothing....

I need to find specific info on the differenced between the pull and push clutches..

I have an ACT Push clutch from a 2002 WRX,
IF I can - I would like to put it into my 2000 OBS.

I know the pull ( mechanical linkage ) and push ( hydraulic w/ slave cylinder ) difference -

I was planning to swap the pedals, brake booster master cylinders and slave..
I need to make sure there are no other parts.

Does the clutch release fork need to be changed ? Any other parts, brackets, Ect that I will need.
 

·
Registered
MY99 GF4 EJ227 JDM 6spd
Joined
·
5,262 Posts
'02 WRX is PULL style. '06+ WRX is push style.
You can put a clutch made for the 2.5RS onto yours. If it is for WRX, it will not fit yours. Maybe '06+ WRX clutch will..not certain.

I run Exedy stg1 for the 2.5RS, mine is not hydralic...it works no problem. The hydralic system only PUSHES the pressure plate springs/fingers.
 

·
Registered
MY95 Impreza 207C
Joined
·
585 Posts
7mgte92runner said:
I know the pull ( mechanical linkage ) and push ( hydraulic w/ slave cylinder ) difference -
The "pull" linkage of the cable clutch is actually push style clutch, despite where the actuation position is located. It is not the same as a true pull style clutch of lets say a MY02-MY05 WRX.
 
1 - 4 of 4 Posts
Top