Subaru Impreza GC8 & RS Forum & Community banner
1 - 5 of 5 Posts

·
Registered
05 STi White + 99 RS White
Joined
·
1,828 Posts
Discussion Starter · #1 ·
What a hassle! Put in the sti replica pedals. The brake and clutch are a piece of cake... The accelerator is a different story! Trying to get the screw through the pivot pin is a nightmare. Not enought room because it can only go through one way. Then the hole on the other side didn't match up...

Long story short, it took a pair of pliers (to bend tabs), a dremel (to enlarge the hole), and removing the gas pedal.

They work and look great though. Heel Toe has never been as easy.

Thanks to Peaty for the instructions for taking the pedal out. ;)

Rob
 

·
Registered
05 STi White + 99 RS White
Joined
·
1,828 Posts
Discussion Starter · #3 ·
Yup, they helped. The only thing that was more frustrating was trying to get all of the Cobb intake into the car with the MAF adapter!:run: :whine: :yikes:
 

·
Registered
05 STi White + 99 RS White
Joined
·
1,828 Posts
Discussion Starter · #7 ·
I'm not too worried about the dead pedal. I have a plastic one that works okay. The pedals were mainly because they were a cheap way to make heel-toeing easy.
 

·
Registered
05 STi White + 99 RS White
Joined
·
1,828 Posts
Discussion Starter · #9 ·
It would most likely need to be fabricated. It's not a standard screw.

Try contacting henry at Revolutions Motorsports. He sells replica sets. Maybe he can get his hand on an extra.;)
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top