Subaru Impreza GC8 & RS Forum & Community banner

181 - 200 of 358 Posts

·
Registered
95 impreza wagon
Joined
·
735 Posts
Discussion Starter #188
got a single stage for the engine bay..




Won't look much different but should hold up a little better.
 

·
Registered
95 impreza wagon
Joined
·
735 Posts
Discussion Starter #190
nah, thats the pigment combination. It will just be basically the same color. A light, matte gray.

once it stops being so effing cold in seattle.
 

·
Registered
95 impreza wagon
Joined
·
735 Posts
Discussion Starter #192
got the garage "cleaned up" so I can spray the engine bay..




got the hatch on and fitted the midspoiler


started looking at how to fit the Syms replica top spoiler but it looks like I have to cut out the middle section so it sits flat and then use just the 2 holes on the outter brackets to hold it down.

Got the pistons out of the calipers finally with the air attachment for my compressor. Took a few tries and some convincing for the 'furthest' piston to move.



gonna derust the pistons and get the calipers powder coated.
 

·
Registered
95 impreza wagon
Joined
·
735 Posts
Discussion Starter #196
another menial update..

intake manifold is stripped and ready for powder



best way to clean injectors? Bonus is I found these AN fitting rail adapters for the fuel rails from my last build.. SCORE!


anyone got a better method than this? so much work..


bucket full of stuff to de-rust!
 
181 - 200 of 358 Posts
Top