Subaru Impreza GC8 & RS Forum & Community banner
1 - 2 of 2 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I miss my '00 RS 2.5 so much, but...

I'm using an EJ22E from a '96 Legacy Outback in my '74 Chenowth rail buggy. I've been utilizing the stock fuel inlet and regulator + lines for some time without real complaint. However, I am rebuilding after having heads redone and coming up short on finding an AN-6 fitting for the inlet side. I am eventually going to install an external FPR, but for now I need a better plumbing/routing solution for the OEM hard line to the driver-side inlet of the fuel rail. I already have two adapters for the FPR side, which is 11mm I believe? Measuring the OD of the fuel hardline is about 8mm. Is there such an animal? I anticipate it being pretty dumb simple to fab, but is anyone doing so?

Thanks again for your patience with a loser who sold his favorite 2-door... sigh
 

· Registered
Joined
·
2,027 Posts
I know the times I put AN fuel line fittings on cars the only non-AN fitting was where the fuel line comes out near the brake booster. It was just a regular clamp. I thought it was dumb, but it's what the people want!
 
1 - 2 of 2 Posts
Top