Subaru Impreza GC8 & RS Forum & Community banner

Jdm ej253 swap issues

2K views 0 replies 1 participant last post by  Trevs_99 
#1 ·
Hey guys, I recently swapped my 07 impreza with a jdm ej253 with avls after my motor blew, after just swapping the intake manifold and wiring harness it ran for like 2 months then stopped. Was told to swap timing sprockets to usdm and I did, still no start, replaced all sensors coil pack, spark plugs, new battery, new timing belt, and still won’t start, fuel is getting to injectors, fuel pump is kicking on, but not getting spark. So I tested my crank sensor pins and it’s getting good ohm readings, but when cranking over it only gets 1.3v so I assume that’s why I’m not getting spark, it gets 1.3v all the way to the ecu, swapped the ecu and same thing. What could I be missing? Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top