Subaru Impreza GC8 & RS Forum & Community banner

1 - 2 of 2 Posts

·
Registered
2000, RS, White
Joined
·
93 Posts
Discussion Starter #1 (Edited)
I have been searching the site for a while now and can't seem to find any information on the installation of an aftermarket hub and wheel install. There are a few that show people just taking out the clock spring and installing it but there is more to it then just remove and replace.

I am looking for the proper Ohm resistor for the airbags and, if possible, modifications to the clock spring so I can retain it. There is also very little mention of the horn wire (ie. its color, gauge, and modified length).

If anyone knows of a write-up elsewhere they can link that would be great.


Search: DIY: Hub install, Works Bell, MOMO, Nardi, Sparco, NRG, Quick release.
 

·
Registered
1997 WRX
Joined
·
151 Posts
When I installed mine it was pretty straight forward after i took off the steering wheel and my works bell hub came with all the necessary wires and resistors if i remember correctly. I don't have any lights for an airbag and my horn works.
 
1 - 2 of 2 Posts
Top