Subaru Impreza GC8 & RS Forum & Community banner

1 - 2 of 2 Posts

·
C U Next Tuesday
01 RS-T 390.3awhp/405tq
Joined
·
660 Posts
Discussion Starter #1
Anyone know where I can get a 2-D or 3-D CAD drawing with measurements of the gauge housing for a GC8? It would make my life easier in making a bezel
 

·
Registered
Joined
·
229 Posts
I don't know of any 3-D ones. What I did was create in Visio a template with circles for 2 1/16" guages for just the little flat face plate that the guages would be mounted to. I then cut out the template, pasted it to my ABS plastic sheet and used a hole saw to drill where the circles were then just cut around the template and it was a perfect fit. It ain't professional but it worked.
 
1 - 2 of 2 Posts
Top