[Stoney]

Whats goin on people hope everyone is doing well. Wondering if anyone has a GC to STI knuckle laying around or a link, where I could fine em. Been trying to hit up L&E no response... I'm planning doin a whole crossmember swap. Just building one on the side on top of some saw horses, then swapping em. So far I have a Koyo 59 rack brand new very skeptical on the ratio, but a good find I couldn't pass up for $235, Koyo 59 part # 2Z02001. Pic posted below if anyone has any info pls let me know. It looks identical to an 04 STI rack. I called subaru n they didn't even know maybe I'm looking at the wrong part #. Any help is appreciated have a good day yall.

 

[mike-tracy]

What you could do is buy the STI piece and have a welding shop weld that to your GC one, making it the same length as the GC. That's literally what L&E does.

 

[powattackpow]

Was the rack the correct one? How’d it turn out

 

[AliBenn]

Well what ESC did on mine (no issues since 06)
Sti rack
Sti otr tie rods
Sti xmember
Sti spindles
But
Had to take spindles to machine shop and slot top or bottom(forgot) strut mount hole
Guessing top but one of the holes on top ear of spindle was not touched

from what I understand, will fit NP
But your ride height will be like a forester

 

[EMDGP40]

I believe all of the Koyo59 are the quicker ratio.
When I did the swap I had an issues with air in the rack, so I replaced all of the line O-rings, I also swapped the lower hardline from the GC rack to the sti rack, because the sti is a soft line. But that was just academic.
Here are the part numbers for all of the O-Rings if anyone needs them.

1. 31260GA030 x 2
2. 34123AA040 x 2
3. 31260GA030 x 2
4. 731259130 x 2