Subaru Impreza GC8 & RS Forum & Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I am looking for a vendor or place that sells or makes a stainless steel 2.5" mid section for the RS? thanks justin
 

·
Registered
Joined
·
392 Posts
wouldn't 3" piping be too large for an NA rs? i've always been under the assumption that 2.5 is as large as a NA should go for the 2.5L engine..

What's the figure on gains for the 3 inch piping? :confused:
 

·
GC8 FTW
Joined
·
7,470 Posts
well since this is the FORCED INDUCTION section i would hope my suggestions are read for FORCED INDUCTION purposed thank you '0wned'
 

·
Registered
Joined
·
247 Posts
haha jeez.. that was harsh. anyways, 3'' would provide more free flowing exhaust but itll probably be a lot louder. 2.5'' isnt too bad in my opinion. i'd go with a nice 2.5''. just have one custom built for your car.
 

·
GC8 FTW
Joined
·
7,470 Posts
well ...........i thought it was rather obvious.....:p......why not get like six catalytic converters on your exhaust while your at it...cat's help NA performance :p
 
1 - 6 of 6 Posts
Top