Subaru Impreza GC8 & RS Forum & Community banner

21 - 40 of 98 Posts

·
Registered
A Blue RS
Joined
·
2,974 Posts
Discussion Starter #22
So after trying to pull the center diff and failing I picked up a new trans and on the next day Mr.Smith use a pry bar and two hits and gets it out
uploadfromtaptalk1390198565722.jpg
But the trans purchase was not in vain upon inspections the output shaft gear had broken teeth so that was junk anyways

But now the car runs! And runs good on the new trans!
uploadfromtaptalk1390198660766.jpg

Oh and I got my retros in (pics later when I take good ones), the new trans came with a act streetlite and stage 1 clutch so we decided to use those instead of my OEM clutch car feels much better now!
 

·
Registered
A Blue RS
Joined
·
2,974 Posts
Discussion Starter #32
A few people have been asking me about my retrofits so here is the parts list and a few pics the car is filthy sorry

Subaru headlight housing
Matsushita gen IV ballast, with morimoto pigtails
Philips D2S bulbs 85122
Morimoto H4 harness with controller
TRS ocular shrouds, I need to redo these
D2S mini projectors

uploadfromtaptalk1391718179995.jpg
uploadfromtaptalk1391718237851.jpg
uploadfromtaptalk1391718371162.jpg
 

·
Registered
A Blue RS
Joined
·
2,974 Posts
Discussion Starter #37
yay more words that don't help an electronics impaired person such as myself. :unamused:
THERE IS NOTHING ELECTRICAL THE HARNESS IS PLUG n PLAY, you literally bake the headlight and slip the projectors in you don't even need to pull the reflector out. all you remove is the halogen shroud
 

·
Registered
A Blue RS
Joined
·
2,974 Posts
Discussion Starter #40
Limpy is once again in repair mode
uploadfromtaptalk1393046764995.jpg
Was getting some noises out of the center of the trans and after the last trans I decided to be proactive about it this time, seems like the transfer bearing were going there was a bunch of scoring on the output shaft , replaced the output and bearings just letting the rtv dry overnight.

Also my ****ing Subaru's hate me it seems like every other time I work on the drive line I get punched in the face by something this time it was the shift knuckle
uploadfromtaptalk1393046934359.jpg

I'll update once the car is running again.
 
21 - 40 of 98 Posts
Top