Subaru Impreza GC8 & RS Forum & Community banner

1 - 5 of 5 Posts

·
Registered
Joined
·
323 Posts
Discussion Starter #1
I guess they were brittle.. I attempted to start my motor up after I was done and I noticed the wire to the crank sensor was pretty much gone with the wires.. Now I have another connector I can splice but I need to know which wire is what on the crank sensor.
 

·
Registered
00 RS, 01 RS, 08 STI daily
Joined
·
12 Posts
It should be a 2 wire sensor and the pins are not hard to remove, I would say solder them and plug it in. If it doesnt start swap the wires. Definitely need engine information for other members to tell you wire colors and such.
 

·
Registered
Joined
·
323 Posts
Discussion Starter #3
It should be a 2 wire sensor and the pins are not hard to remove, I would say solder them and plug it in. If it doesnt start swap the wires. Definitely need engine information for other members to tell you wire colors and such.
Looking at the service manual it says the wires should be blue and white, however I don't know what to make of it with the image they show.
 

Attachments

1 - 5 of 5 Posts
Top