Subaru Impreza GC8 & RS Forum & Community banner

1 - 4 of 4 Posts

·
Registered
99 WRB GC V9 Spec C RA recce
Joined
·
914 Posts
Discussion Starter #1
I decided to seam weld the car, and while at it redo the wiring that has been extensively modified here and there over the years




I plan to swap to GD MY05 dash as well, since I am running DBC EJ207 engine wiring (AVCS)
The car is equipped with 6spd DCCD, but I plan to control it with an aftermarket unit

My question is, what would be the best donor to buy the wiring from? Headlights to taillights and everything in between. I figured, it would be easier to swap things like doors and front/rear lights, than merge

While JDM Spec C would be best, it runs short when you flip it around into LHD car, so that's a pita

Also I don't care about ABS because I don't have it, so that piece of wiring will be gutted out
 

·
Premium Member
2001 SRP 2.5RS/RA/SOHC Monster
Joined
·
2,777 Posts
If you plan on doing the full harness swap, I would match it to the dash.
 
1 - 4 of 4 Posts
Top