Subaru Impreza GC8 & RS Forum & Community banner
1 - 4 of 4 Posts

·
Registered
stm99,flatblack99,07sti,blk98
Joined
·
566 Posts
Discussion Starter · #1 ·
Welp just ordered a set of BC Racing Coilover from the nice guys at importimage. depending on my setup... 05wrx hubs and trans conversion will these coilovers work? importimage said they are the same i belive them. i will put it to the test in my journal.thanks any in put :)
 

·
Registered
2000 Impreza 2.5RS BRP
Joined
·
425 Posts
all hub -> strut mounting point for all subaru imprezas are the same except for the front on the 05+ STI.

5x100 hub mounting location are all the same.
 

·
Registered
MY99 GF4 EJ227 JDM 6spd
Joined
·
5,273 Posts
I have GC/GM/GF BC Racing coilovers on my JDM '04 STi spindles/knuckles. They work. I'm guessing they SHOULD work with '05 as well up front, because I just didn't '05 STi suspension swap last week and they looks to be the same but I could be wrong. I know the '05 runs a different shaped spindle and hub design, but the McPherson style strut makes me think it'll still fit. I could be wrong.
 

·
Registered
2000 Impreza 2.5RS BRP
Joined
·
425 Posts
to clarify if my post was confusing:

93-2007 impreza 2.5rs/l/wrx are the same
2004 STI is the same as above

2005-2007 sti uses different front hub spacing and sizing for the strut mount
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top