Subaru Impreza GC8 & RS Forum & Community banner
1 - 20 of 26 Posts

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #1 · (Edited)
Hey, I have a few assorted JDM and USDM parts for sale.


Work VS-XX Wheels

18x8.5 5x114.3 +31 and +26 offset
Comes with Yokohama DNA GP 225/45 ZR18 80-90% tread
Some curbing, but no bends.


high-res photos:
http://www.bakemono-imports.com/rs25/vsxx1.jpg
http://www.bakemono-imports.com/rs25/vsxx2.jpg
http://www.bakemono-imports.com/rs25/vsxx3.jpg
http://www.bakemono-imports.com/rs25/vsxx4.jpg

$1500 OBO shipped


VF23 Turbo.
50k miles, no shaft play.
SOLD


4pot front brakes w/rotors and steel braided lines

700 miles on rebuild, pads, rotors, and lines
SOLD

Paypal: [email protected]

MORE PICTURES INSIDE THE THREAD! Shipping prices are for the 48 contigious states. If you're from somewhere else, PM me for shipping. Please add 3% to the price if paying by paypal. If you don't have paypal, PM me for other arrangements. Also, California residents get to give Arnold an additional 8.25%. :)

HKS Uppipe: $85 OBO shipped
HKS Downpipe: $150 shipped
Apexi Boost controller for PowerFC: SOLD
Visteon radiator w/silicone piping (0 miles): SOLD
STI V3 Intercooler: $125 OBO shipped
Zerosports ABS GC8 spoiler: $325 shipped
Zerosports Carbon Fiber GD spoiler: $350 shipped
1998 RS A/C setup: Make offer
1998 RS ABS setup, minus wheel sensors: Make offer
Work VS-XX wheels 18x8.5 PCD114.3 +26, +31 offset: $1300 picked up, $1500 shipped
 

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #2 · (Edited)
Visteon Radiator w/ Spal fans and silicone tubing. 0 miles on setup.
Installed, but 0 has miles on it. This is pretty much new. The radiator overflow tank has been modified to fit around your A/C lines. Silicone tubing is included as well (normally about $50).

SOLD


GC8 STI V3 Intercooler
Comes with silicone tubing. Has a 5/16" hole drilled in the back for installation of alcohol injection kit. If you're going to install a meth kit on your car, the work is done for you. If not, it shouldn't be hard or expensive to weld up the hole.

$125 OBO shipped

Apexi Boost Controller for PowerFC
These are hard to come by by themselves. If you can find one, they go for $150 + whatever fees you would need to pay someone to buy it for you and get it to you. Tune your boost with your PowerFC if you have one of these!

SOLD

HKS EJ20/25 Uppipe
Only has about 100 miles on it so its still shiny. Made for the VF series turbo.

$85 OBO shipped


HKS GC8 EJ20/25 Downpipe
Made for the VF series turbo.


$150 OBO shipped



Zerosports GC8 Rear Spoiler ABS
The one for sale is unpainted. Comes with mounting hardware. It does not use the standard spoiler holes, so drilling in the trunk will be required.



$325 OBO shipped

S201 Carbon Fiber Scoop
Fits 97-01 Imprezas with the RS scoop. Self tapping screws required for mounting.

$250 shipped


Zerosports GD Rear Spoiler Carbon Fiber
Comes with mounting hardware. There is a small pressure ding on it about 1/4" near the front of the spoiler, caused by someone using incorrect hardware that was too long. It does not use the standard spoiler holes, so drilling in the trunk will be required.


$350 OBO shipped
 

·
Better than you!
1997 LRSWRX, 1998 Lego GT
Joined
·
6,298 Posts
Curious about the radiator also, any more pics or info? What year it fits, capacity, and also do you have any fans for it?

EDIT: Looks like it fits the RS with the opening at the passenger side.

EDIT EDIT: Yay for number 5000! Thats ridiculous. I need a new hobby. :lol:
 

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #5 ·
Does the visteon radiator fits the RS? Is it plug-n-play?
It should fit the RS.
"Part number 7026 for the GC8 (also, **apparently**, fits Forester models up through at least 2005, including XT). This radiator comes with two Spal fans (quite possibly the best aftermarket performance radiator fan company), a nice new overflow tank, radiator cap, and drain plug. Looks like:
"

Curious about the radiator also, any more pics or info? What year it fits, capacity, and also do you have any fans for it?

EDIT: Looks like it fits the RS with the opening at the passenger side.
It has Spal fans. There's a picture above of the backside of the radiator.
 

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #8 ·
Curious about the radiator also, any more pics or info? What year it fits, capacity, and also do you have any fans for it?

EDIT: Looks like it fits the RS with the opening at the passenger side.
You gave me your 5,000th post. I'm honored. :)
 

·
Better than you!
1997 LRSWRX, 1998 Lego GT
Joined
·
6,298 Posts
And you're sending me a radiator, so I'd say we're even! :)
 

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #11 ·
Yep. THat's right, you never saw the car did you? Check out my member profile page, http://www.rs25.com/forums/showthread.php?t=71297&page=27

Those are some pics of the kit mostly installed. I'm taking care of the engine bay before I bother getting paint though, because I'd hate to scratch something while working on the engine.
 

·
Registered
Joined
·
401 Posts

·
ok terrific.
'95 STi RA rep, rhd yo!
Joined
·
5,223 Posts
What pads are included with the 4-pots? OEM or aftermarket?
 

·
Registered
98 SE-R 01 RS
Joined
·
496 Posts
Can the intercooler fit the RS throttle body without shaving anything off?
 

·
Banned
www.bakemono-imports.com
Joined
·
2,636 Posts
Discussion Starter · #18 · (Edited)

·
Registered
1999 Subaru Impreza 2.5 rs-t
Joined
·
890 Posts
1 - 20 of 26 Posts
Top