Subaru Impreza GC8 & RS Forum & Community banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Ok I made a MIL eliminator and when I went to install it the wire colors did not match to anyones posts...The wires I took off were black, black, white and blue. All the ways to hook it up explain it using white, white, black and grey. Anyone know which are the ground and signal wire I need to splice into? Any help would be great...I tired searching but there are no real answers, most posts end before anyone answers the questions. Thanks in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top