BeateRSTI - Subaru Impreza GC8 & RS Forum & Community: RS25.com
 
Private Support i-Trader Ratings Become a Vendor Rules for VendorsModsUsers Contact
Subaru Impreza GC8 & RS Forum & Community: RS25.com
gc8 RSS GC8 Facebook Subaru GC8 Twitter Subaru YouTube Channel Subaru Sticker
 
Login below or Register Now
Mark Forums Read FAQ Advertise
Go Back   Subaru Impreza GC8 & RS Forum & Community: RS25.com > >
BeateRSTI
 
 
Thread Tools
Old 07-25-2013, 10:29 AM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default BeateRSTI

My cobbled together thrashed out RS with too much money dumped into its crappy shell.

Engine/Drivetrain
AVCS EJ205
EJ207 double crossdrilled crankshaft
ej257 connecting rods, balanced
JE 9.5:1 pistons, balanced
ARP Headstuds
King rod/main bearings
11mm oil pump, extra shims
KB oil pickup/windage tray
OEM ej257 oil pan
Custom oil sump baffle plate (diy tomei copy)
Tstat controlled oil cooler sandwich plate
-10 an braided oil cooler lines to top mounted oil cooler
Oem Headgaskets etc
Ver7 STI intake manifold ported TGV deletes
Kinugawa Fuel rails (-6an)
-6an Braided equal length fuel lines
aeromotive fuel pressure reg
LGT twinscroll headers
VF37 turbeh
braided turbo and avcs oil feed lines
Custom 3in aluminum turbo inlet/intake
Rewired for ver7 sti ecu/avcs
carberry rom, speed density, flex fuel, launch control, antilag, etc
GM Ethanol Content Analyzer, wired to an Arduino for frequency to voltage
GM 3 bar MAP sensor
GM IAT sensor
custom AOS
Ebay GD FMIC hacked to fit the GC
3" turbo back exhaust, Catless, two resonators
AEM 320lph Fuel pump
Bosch 1000cc injectors
AEM AFR gauge
Prosport Oil pressure gauge, Glowshit Boost gauge
Ebay 9lb Flywheel (3 years strong)
Ebay XTD clutch (works lol) oem throwout and pilot bearings
JDM LGT 120amp Alternator
CXRacing GD Radiator

Ver7 STI 6spd Transmission viscous center, AP Surtrac Front
06/07 front axles
r160 WRX viscous diff regeared to 3.90. (meh)


Suspension/Brakes
KYB agx struts
Ground control coilover conversion 10" springs 250lb/225lb
TIC lat link Bushings
TIC Trailing arm bushings
Superpro Diff mount bushings
DIY lockdown bolts
Whiteline front control arm bushings
Kart boy solid front and rear sway bar endlinks
02 WRX sedan 20mm RSB/FSB
EBC Orangestuff pads
Stainless braided brake lines
ABS delete/non abs brake lines
SVX 1 1/16 Master
Solid Differential T-brace mounts
Solid trans crossmember mounts
Torque solutions engine/trans mounts
DIY solid dogbone/Pitchstop


Interior/Exterior
suede flocked! dash
stripped: no carpet, rear seats, trunk, sound deadening, door panels headliner etc
02 WRX front seats
center dash triple gauge pod, AFR, boost, oil pressure
ghetto knob
EDM 160mph wrx cluster
DIY bronze shifter bushings
Urethane shifter mount bushings
JDM wrx steering wheel
DIY switch panel, Fuel pump, Igniter/injector power supply, launch control, heater blower motor, antilag

Seibon RB5 replica carbonfiber wing
custom bash bar/ intercooler radiator mount with 4 7" hid spots
custom skid plate
carbon fiber hood
carbon scoop
digi cam black/white/red
sparco mudflaps
blacked out headlight housings
clear black blinker sidemarker and corner lights
ever so functional as f*ck jdm drywall screw style
No front/rear bumper beams


See the end for more updates...



Most Recent


Attached Thumbnails
BeateRSTI-image_zpso1jdlobw.jpg  

Last edited by nhawks; 07-28-2016 at 08:05 AM..
nhawks is offline  
Sponsored Links
Advertisement
 
Old 08-20-2013, 09:24 PM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

Little update, tore down the ej20, basically will need a complet rotating assembly, so ill probably do a hybrid build ej255 bottom end etc. meanwhile I rattle canned the car olive green added some white stars, and painted the rims black.



nhawks is offline  
Old 08-20-2013, 09:28 PM  
rocket455
2.0L
 
Car: 1998 2.5 RS
Join Date: Feb 2011
Location: Suisun City, CA
Trader Rating: (1)
Posts: 79
Default

I'm surprised that they let you keep the motor in your dorm room. I would think that during the health and wellness imspections that they would get you for some sort of hazmat issue
rocket455 is offline  
Old 08-21-2013, 10:48 AM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

Oh, they don't, and probably would. Lol which is why it's been moved back to my truck after tear down. Need to find a cheap storage unit for all my misc subi parts.
nhawks is offline  
Old 11-14-2013, 06:20 AM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

Little update, basically rebuilt the whole front end, wheel bearings ball joints, tie rods/ends, axles, couple new seals here, a bushing and grommet there etc. Then i did the clutch, put a 8.9lb lightweight flywheel exedy oem spec wrx clutch with all new pressure plate throwout/pilot bearings.then came time for some new tires went up to a 225, got a decent deal on some closeout kumho ecsta ast's. Then was bored so i replaced the intake gaskets, along with injector orings, ported the intake manifold a little and gave it some red paint (+25KW). Then went for a drive up into W arkansas real good driving roads, some fun uphill and down hill, switchback/hairpins and some fast wide open turns aswell.





Last edited by nhawks; 11-14-2013 at 06:22 AM..
nhawks is offline  
Old 01-28-2014, 09:55 PM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

Little update, havent done much to the car just little things here and there, did a 3 gauge pod, 4 pioneer speaker all in custom boxes, suede over alot of the plastic interior.

gutted the grille and lower bumper opening.

cleaned up the engine bay and painted a bunch of stuff red. staight piped 3 inch axleback. Ran it at the 1/4 mi best time i ran was a 15.2.

drove it up north over new years to michigan, only went through a few blizzards.



earlier that month i drove my buddies 07 wrx tr for a little bit, further fueling my desire for boost,


finally found a harness i could pick up in michigan, met a guy thats on these forums, but doesnt really post except for his FS threads, had a nice full sti swapped rs that he was working on,

along with a turbo foz

got back home to louisiana two weeks later 2600mi logged on the rs, with about 1000 of that being without ever seing pavement under the snowpack lol.




only problem i had is when some ice blew my window out in illinois.

then came time to start on my wrx harness,



then labeled everything, (little tgv delete project in the back)

and now waiting for a little more $$ and out to dallas to pick up a jdm ej205
nhawks is offline  
Old 01-28-2014, 10:05 PM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

some winter hooning...







rb25 swapped built 240, 428whp


honda civic si hunting

nhawks is offline  
Old 05-03-2014, 12:41 AM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default


Went to pick up a sti 6spd and the guy was cleaning out some parts so picked up a twin scroll vf37, along with a sti manifold tgv less with 750cc injectors etc. The 6 SPD I got is a v7 non dccd 3.90 with LSD front diff. Came with starter and shift linkage wiring sensors etc. Still need front driveshafts, regear my rear diff, and a auto driveshaft.

Last edited by nhawks; 05-03-2014 at 02:50 PM..
nhawks is offline  
Old 05-03-2014, 02:32 PM  
da5dime
3.3L
 
Fav Mod: CA Legal 207 w/ 6 Gears
Join Date: May 2010
Location: Simi Valley, CA
Trader Rating: (25)
Posts: 813
Default

Interesting...JDM parts on a Merica'd RS!?!? LOL, just j/k, build looks great man!
__________________
Burzinski: Watch it! Stop donating to cancer research and "awareness"!
da5dime is offline  
Old 05-03-2014, 02:46 PM  
nhawks
2.0L Turbo
 
Fav Mod: Ricer Red parts for +25KW
Join Date: Jul 2013
Location: Grand Forks ND
Trader Rating: (0)
Posts: 1,918
Default

I got jdm i got ukdm i got EDM i haz all the DM's lol
nhawks is offline  
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 05:41 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright © 2019 VerticalScope Inc.
Designed & Powered by Domain Architect