got the replacement heater controls in. Is there usually such a big gap at the bottom? I can see through to the floor
got most of the intake manifold together. Need to get my fuel rails welded with AN fittings so I can do the parallel mod
did some wire brushing on the block - should I clear coat it or paint it with some engine paint silver? or just leave it.
this is as clean as I've been able to get the head surface with just chemicals and a plastic scraper and a rag. Think its good enough?
and anyone got the part number for a new one of these?
I've got it soaking in rust remover at the moment but I doubt it'll get it all