Itís been 15 days since I have driven the car. A few weekends ago I put it on stands to fix a small but persistent Power steering leak, do an oil change and while in there, install the oil cooler I bought two years ago.
The problem is, the cooler I purchased is just way too large to fit practically when mounts and lines are attached. Sheet metal and bumper need to be cut to make it work, and it really is overkill. So I have ordered a new core about half the size and have been waiting for it to arrive ever since. Apparently when some vendors say ďin stock, ships in 2-3 business daysĒ what they really mean is they will contact their supplier in the UK sometime in the next week to have one shipped and not tell the customer. At least I donít need the car and havenít had a lot of time to work on it anyway.
I did have time to work on the steering though. The leak was on top of the crossmember between the hardlines on the rack and the hoses going up to the pump. I got a brand new set of lines for an EJ25D to replace the used EBay ones I have been using ever since the swap. I also installed a new 04í STI steering rack. I used the L&E Fabrications GD-GC steering coupler as it wasnít much more expensive than if I bought a GD coupler and made one myself, and it saved me all the labor. The L&E coupler works, but it was pretty nasty. The splines were all messy so i really had to clean them out and the threads for the bolt had to be re-tapped.
Other than being really annoying, everything fit ok and so far no leaks. As soon as the new oil cooler comes in Iíll get to work on that.
So the 25 row Mocal was way too big. Not only did it have hard interference with the bumper beam in just about every location but it also was a bit overkill. Note the mangled A/C condenser and damage from the original owner as well as overspray from the ďfixĒ Somehow that thing is still working problem free after all of these years!
So I got a little gun shy and ordered a MUCH smaller cooler, hopefully not too small. This one is a Setrab 1 series 16 row. It fits much nicer. If I find I need something larger I can move up to the wider version and still be okay.
Yes I still have the factory water to oil heater/cooler hooked up. I couldnít find any real data on how it affects oil temps. I figure it canít hurt to have it heating the oil up in the cold. And hopefully it doesnít warm it up too much post air-oil cooler, but thatís what Iím looking to find out. In theory, the oil should be noticeably warmer than the coolant anyway, right? I also didnít want to pull the timing belt to swap the water pumps out at this time.
Unfortunately I lost the new oil temp sensor I was going to install so I am waiting to fill and leak check until the new one goes in, hopefully tomorrow. With some luck Iíll get it wrapped up this weekend.
Ive been driving it a bit more and the oil temps seem to be.... low. Sitting stuck in traffic in 80 degree F weather, I was seeing about 90C (about 195F) on the gauge. As soon as I get moving the temps drop to 65-70C (150F-160F). And I do have a 180F thermostat in the sandwich plate. Iím sure they will be higher on the track, but itís quite a bit too cool right now.
My baja with just the factory oil cooler/warmer sits right around 90C in the summer.