So you have to inspect the harness for areas where it's soldered? I thought beachbum12tree said he had that taken care of by Forman soooo there shouldn't be any soldered wires in the harness o.O
Believe that the are all soldered connection, but are wrapped with electrical tape and not covered with heat shrink. I have OCD bad when it comes to this and why I am usually the one to do any harness conversions and why my friends get me to do theirs or help them with theirs. I only suspect this because I know that is the way the ic sprayer pump is done in the trunk. Just hope I don't have to bust out the soldering iron to separate the wires to get the shrink on and can just de-pin them and slip on the heat shrink, but that also depends on how the connected the wires too ( Y vs. --)
Seems to be ok, but I didn't install it and don't have a reason to remove it yet.
Updated---pulled Bakemono scoop & fit is perfect. Also the GD under the hood piece fits just fine as well, but you have to make your own attachment points for the front side of it...the rear you can use stock mounting locations.
Had fun at Gillman Big Event 5. Car isn't really a show stopper, but put it in anyway just to get a good parking spot lol. Got a fair amount of work done to her before hand considering how busy life keeps me. Updated the first page with relavent info.